Home > Audio & Video > Adapters > RCA > Attenuators >

10-106 Calrad Speaker Level to Line Level Converter, 60 Watt Stereo - Passive Device

Speaker Level to Line Level Converter, 60 Watt Stereo - Passive Device | Calrad Electronics 10-106


 
Alternative Views:


Brand: Calrad Electronics
Manufacturer Part No. 10-106
- 10-106 Datasheet

Product No Longer Available

Description
 

Calrad Electronics 10-106 Speaker Level to Line Level Converter, 60 Watt Stereo - Passive Device

Use the Calrad 10-106 adapter to convert a speaker-level signal to a line-level signal. It's perfect for sending the amplified output of a multi-room audio system to a more powerful amplifier, or adding a second amp to power more speakers. The adapter features a four-conductor terminal block for left + right speaker wire inputs and female RCA stereo left + right output jacks. Setup: (Output with no speakers used from amplifier) The output level from the amplifier should be set at minimum level setting first to avoid over driving the 10-106 converter, this will also prevent the amplifier from pushing out more wattage then needed. Next adjust the 10-106 gain controls to achieve the desired signal conversion to line level. Setup: (Output with speakers used from amplifier, 10-106 parallel speaker connection) The output of the amplifier should be set at the normal output setting that will be used on a regular basis, then adjust the 10-106 gain controls to achieve the desired signal conversion to line level. Note! That any significant change in the amplifier signal output will have a direct effect and change in he signal output of the 10-106 converter that could result in a distorted line level output.

Works with these Calrad Audio Baluns:
40-DA01, Passive Balanced RCA Signal Converter: 40-DA01
40-DA02, Passive Balanced RCA Signal Converter with PIGTAIL : 40-DA02
95-1046-S, Stereo RCA Audio Balun Over Single Cat5e/6 Cable: 95-1046-S
95-1046-S1, Stereo Analog Ground Isolation Audio Balun with IR, RS232, RS422 or RS485 Connectivity : 95-1046-S1

Specifications:
  • DC Power: None (Passive Device)
  • Input Impedance: 4-8 Ohm
  • Maximum Input Power: 60 Watts
  • Frequency Response: 20-20Khz
  • Isolation: Transformer based
  • Grounding: Independent speaker grounds, independent line level grounds
  • Output Level: 200-300mv, Gain 0-2Vpp
  • Input Jack: 1 x 4 Position terminal block (Accepts up to 20-24 gauge wire)
  • Input Cabling: Use 20-24 AWG speaker cable
  • Output Jacks: 2 x RCA female (White & Red Inserts)

Share your knowledge of this product. Be the first to write a review about this product »